Laval & Greater Montreal

Garage Door Adjustment in Laval & Greater Montreal

Spring tension, travel limits, force settings, sensor alignment and track spacing brought back into adjustment.

Laval, North Shore, South Shore, Montreal, West Island, Terrebonne, Mascouche, Rosemère, Blainville, Boisbriand, Sainte-Thérèse, Mirabel, Saint-Eustache, Deux-Montagnes, Bois-des-Filion, Lorraine, Longueuil, Brossard, Saint-Hubert, Saint-Lambert, Boucherville, La Prairie, Candiac, Chambly, Saint-Bruno-de-Montarville, Beloeil, Varennes, Chomedey, Laval-des-Rapides, Pont-Viau, Duvernay, Vimont, Auteuil, Sainte-Rose, Fabreville, Sainte-Dorothée, Laval-Ouest, Saint-François, Saint-Vincent-de-Paul, Saint-Laurent, Ahuntsic-Cartierville, Villeray–Saint-Michel, Rosemont–La Petite-Patrie, Saint-Léonard, Anjou, Montréal-Nord, Mercier–Hochelaga-Maisonneuve, Rivière-des-Prairies, LaSalle, Verdun, Lachine, Côte-des-Neiges–NDG, Le Plateau-Mont-Royal, Outremont, Mont-Royal, Côte-Saint-Luc, Pierrefonds-Roxboro, Dollard-des-Ormeaux, Pointe-Claire, Kirkland, Beaconsfield, Dorval, L'Île-Bizard, Sainte-Anne-de-Bellevue, Baie-d'Urfé
Diagnosed before quoted
Residential & commercial
Emergency calls prioritised
Across Greater Montreal

What we do

Garage Door Adjustment in Greater Montreal

Many garage door complaints are adjustment problems, not broken parts: a door that stops short of the floor, reverses for no reason, leaves a gap on one side, or will not hold position halfway.

Adjustment is precise work. Spring tension has to be right for the door's weight, and the opener's limits and force have to match the door's actual travel.

What the job includes

  • Re-tension springs so the door balances by hand
  • Set opener open and close travel limits accurately
  • Set up and down force to the minimum that works safely
  • Align photo-eye sensors and verify auto-reverse
  • Correct track spacing and level the door in the opening
  • Adjust the bottom seal contact so the door seals without bouncing

Common problems

What usually goes wrong

These are the failures we are actually called out for, and what each one usually means.

A gap at one corner when the door is closed

The door is not sitting level in the opening, or the track spacing is off on one side.

The door stops short of fully closing

The close limit has drifted, or a force setting is too low to complete travel.

The door will not stay halfway open

Spring tension is out. Once re-tensioned, the door holds where you leave it.

Our process

How the job runs

  1. 1

    Step 1

    Contact AAL Garage Doors and describe what the door is doing.

  2. 2

    Step 2

    A technician diagnoses the door, opener and hardware on site.

  3. 3

    Step 3

    We explain what is wrong, what it takes to fix it and what it costs.

  4. 4

    Step 4

    We complete the work with parts sized for your door.

  5. 5

    Step 5

    We balance, cycle and safety-test the whole system before leaving.

Why AAL

Why homeowners call us back

  • Adjustments done by measurement, not guesswork
  • Safety reverse re-tested after every change
  • Cheaper than replacing parts that are not worn out

Fastest diagnosis

Send a photo of the problem

A picture of the spring above your door, the opener unit, or the way the door is sitting tells us more in ten seconds than a phone call does in ten minutes. Send one and you get a real assessment — including when the fix is something you can do yourself.

  • The spring bar above the door
  • The opener unit and its model label
  • How the door sits when it stops
  • Any frayed cable near the bottom bracket

Ready when you are

Attach photos straight to the quote form, or send them over WhatsApp if that is easier.

Reviews

Garage Door Adjustment — what customers say

Jobs like yours, across Laval, Montreal and the surrounding suburbs.

“Spring went on a Sunday morning with the car locked inside and my wife needed to be at work. Sent a photo over WhatsApp, got a straight answer on what it was and what it would cost before anyone drove out. Both springs replaced and the door is quieter than it has been in years.”

Marc-André L.

Chomedey, Laval · February 2026

“Two other companies told me the whole door needed replacing. These guys came out, found a bent track and worn rollers, fixed both, and charged a fraction of what I was quoted elsewhere. Honest is the word I would use.”

Sylvie T.

Sainte-Dorothée, Laval · January 2026

“Opener finally died after about fifteen years. They walked me through belt versus chain given the bedroom sitting right above the garage, installed a belt drive, and set the travel limits properly. You genuinely cannot hear it from upstairs now.”

David R.

Saint-Laurent, Montreal · March 2026

Pricing

What actually drives the price

No two garage door jobs price the same, and any company quoting you a firm number before seeing the door is guessing. Here is what changes the figure — you get the real one after the diagnosis, before any work starts.

JobWhat moves the priceWorth knowing
Torsion spring replacementDoor weight and height, single vs matched pair, spring cycle ratingAlways replaced in pairs on a two-spring door so balance is kept.
Cable replacementWhether drums need re-spooling, condition of the bottom bracketsUsually paired with a balance check, since a snapped cable means the door ran uneven.
Opener repairGear kit vs logic board vs sensors, brand and age of unitA stripped nylon gear is a repair. A failed board on a 15-year-old unit often is not worth it.
Opener replacementChain, belt or wall-mount; horsepower for door weight; accessoriesBelt drive is worth it when there is a bedroom above the garage.
Panel / section replacementAvailability of a matching section, insulated vs non-insulatedHas to be ordered to match — this is the one job that is rarely same-visit.
Full door replacementSize, insulation R-value, window inserts, new tracks and hardwareIncludes correctly sized springs and a re-set opener, not just the door.

Fastest way to a real number: send a photo of the door, the spring above it, or the opener unit. WhatsApp is usually quickest — you often get an assessment back before a technician is dispatched.

FAQ

Garage Door Adjustment questions

Can I adjust the spring tension myself?

No. Torsion spring adjustment requires proper winding bars and technique; it is the highest-risk task on a garage door.

Why does the door leave a gap at one side?

Either the door is not level in the opening, the track spacing differs side to side, or the slab is uneven. Adjustment corrects the first two; a threshold seal handles the third.

Is adjustment included with other repairs?

Yes. After any spring, cable or opener work we re-balance the door and re-set the opener as part of the job.

Need Garage Door Adjustment?

Send a photo of the problem and we will tell you what it actually needs — often before a technician is dispatched.

Laval • Montreal • North Shore • South Shore • West Island